Follow

If GS1100 doesn’t behave neither a beep nor vibration after it tries to read a tag; besides, if you press and hold the SCAN button for 15 seconds, SCAN LED lights around 10 seconds and then goes off

The buzzer and the vibration of GS1100 were probably set to “off”. Use the software GuardScan Monitor to set “buzzer” and “vibration” to “on”. Note: Only GS1100 with firmware vision V1.01R0 or above and hardware version REV. C or above is allowed to change buzzer and vibration settings by the software. (You will see firmware version by using “Get Version” function of the software GuardScan Monitor and see hardware version by taking a look at “MFG. NO” on the label at the back of GS1100.)

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk