If you want to set the fingerprint reader of TR4050-10 to default settings

Follow the steps as below.

1. Install the software Mifare Reader Utility. (If you don’t have the software, contact GIGA-TMS.)
2. Connect TR4050-10 with your computer via RS232 cable.
3. Power on TR4050-10.
4. Open the software Mifare Reader Utility.
5. Click [Auto Scan], once TR4050-10 is detected, “SF600-00 On COM Number” message will appear at the bottom of the window.
   
6. Under [Mifare] tab, set the same settings as below. Then click [Update Reader] to save the settings to TR4050-10.
   
7. Under [Reader] tab, set the same settings as below. Then click [Update Reader] to save the settings to TR4050-10.
   
8. Under [ABA-TK2] tab, set the same settings as below. Then click [Update Reader] to save the settings to TR4050-10.
   
9. Under [LED/Buzzer] tab, set the same settings as below. Then click [Update Reader] to save the settings to TR4050-10.
   
10. Close the software.